March 17th, 2012, 08:34 PM
Clog in PME 00 tip...
I think I have some RI stuck in the very tip of my 00 PME tip. I've tried using a sewing pin to open up the whole but it will not go in far enough. Any advice on how to unclog this tip? I thought I might try soaking it in boiling water to loosen up the RI. Maybe add some baking soda to the water, too.
March 17th, 2012, 08:55 PM
Never mind. The hot water with baking soda did the trick! YAY! It was actually a tiny piece of hard plastic. I have no idea how it got in there either. Strange.
Last edited by Ruth D; March 17th, 2012 at 08:57 PM.